Chlorhexidine 처리가 상아질 접착제의 미세인장결합강도에 미치는 영향
Effect if chlorhexidine on microtensile bond strength of dentin bonding systems
2
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
The purpose of this study was to evaluate the effect of chlorhexidine (CHX) on microtensile bond strength (μTBS) of dentin bonding systems. Dentin collagenolytic and gelatinolytic activities can be suppressed by protease inhibitors, indicating that MMPs (Matrix metalloproteinases) inhibition could be beneficial in the preservation of hybrid layers. Chlorhexidine (CHX) is known as an inhibitor of MMPs activity in vitro. The experiment was proceeded as follows : At first, flat occlusal surfaces were prepared on mid-coronal dentin of extracted third molars. GI (Glass Ionomer) group was treated with dentin conditioner, and then, applied with 2 % CHX. Both SM (Scotchbond Multipurpose) and SB (Single Bond) group were applied with CHX after acidetched with 37% phosphoric acid. TS (Clearfil Tri-S) group was applied with CHX, and then, with adhesives. Hybrid composite Z-250 and resin-modified glass ionomer Fuji-II LC was built up on experimental dentin surfaces. Half of them were subjected to 10,000 thermocycle, while the others were tested immediately. With the resulting data, statistically two-way ANOVA was performed to assess the μTBS before and after thermocycling and the effect of CHX. All statistical tests were carried out at the 95 % level of confidence. The failure mode of the testing samples was observed under a scanning electron microscopy (SEM). Within limited results, the results of this study were as follows; 1. In all experimental groups applied with 2 % chlorhexidine, the microtensile bond strength increased, and thermocycling decreased the microtensile bond strength (P > 0.05). 2. Compared to the thermocycling groups without chlorhexidine, those with both thermocycling and chlorhexidine showed higher microtensile bond strength, and there was significant difference especially in GI and TS groups. 3. SEM analysis of failure mode distribution revealed the adhesive failure at hybrid layer in most of the specimen, and the shift of the failure site from bottom to top of the hybrid layer with chlorhexidine groups. 2 % chlorhexidine application after acid-etching proved to preserve the durability of the hybrid layer and microtensile bond strength of dentin bonding systems.
Abstract
The purpose of this study was to evaluate the effect of chlorhexidine (CHX) on microtensile bond strength (μTBS) of dentin bonding systems. Dentin collagenolytic and gelatinolytic activities can be suppressed by protease inhibitors, indicating that MMPs (Matrix metalloproteinases) inhibition could be beneficial in the preservation of hybrid layers. Chlorhexidine (CHX) is known as an inhibitor of MMPs activity in vitro. The experiment was proceeded as follows : At first, flat occlusal surfaces were prepared on mid-coronal dentin of extracted third molars. GI (Glass Ionomer) group was treated with dentin conditioner, and then, applied with 2 % CHX. Both SM (Scotchbond Multipurpose) and SB (Single Bond) group were applied with CHX after acidetched with 37% phosphoric acid. TS (Clearfil Tri-S) group was applied with CHX, and then, with adhesives. Hybrid composite Z-250 and resin-modified glass ionomer Fuji-II LC was built up on experimental dentin surfaces. Half of them were subjected to 10,000 thermocycle, while the others were tested immediately. With the resulting data, statistically two-way ANOVA was performed to assess the μTBS before and after thermocycling and the effect of CHX. All statistical tests were carried out at the 95 % level of confidence. The failure mode of the testing samples was observed under a scanning electron microscopy (SEM). Within limited results, the results of this study were as follows; 1. In all experimental groups applied with 2 % chlorhexidine, the microtensile bond strength increased, and thermocycling decreased the microtensile bond strength (P > 0.05). 2. Compared to the thermocycling groups without chlorhexidine, those with both thermocycling and chlorhexidine showed higher microtensile bond strength, and there was significant difference especially in GI and TS groups. 3. SEM analysis of failure mode distribution revealed the adhesive failure at hybrid layer in most of the specimen, and the shift of the failure site from bottom to top of the hybrid layer with chlorhexidine groups. 2 % chlorhexidine application after acid-etching proved to preserve the durability of the hybrid layer and microtensile bond strength of dentin bonding systems.
참고문헌 (35)
- Van Meerbeek B, "The clinical performance of adhesives", J Dent, 26, pp.1~20 (1998)
- Hashimoto M, "In vitro degradation of resin-dentin bonds analyzed by microtensile bond test, scanning and transmission electron microscopy", Biomaterials, 24, pp.3795~3803 (2003)
- Okuda M, "Long-term durability of resin dentin interface: nanoleakage vs microtensile bond strength", Oper Dent, 27, pp.289~296 (2002)
- De Munck J, "Four-year Water Degradation of Total-etch Adhesives Bonded to Dentin", J Dent Res, 2, pp.136~140 (2003)
- Pashley DH, "Callagen Degradation by Host-derived Enzymes during Aging", J Dent Res, 83, pp.216~221 (2004)
- Gendron R, "Inhibition of the activities of matrix metalloproteinases 2, 8, and 9 by chlorhexidine", Clin Diagn Lab Immunol, pp.437~439 (1999)
- Hashimoto M, "In vivo degradation of resin-dentin bonds in humans over 1 to 3 years", J Dent Res, 79, pp.1385~1391 (2000)
- Chaussain-Miller C, "The role of matrix metalloproteinases(MMPs) in Human Caries", J Dent Res, 85, pp.22~32 (2006)
- Sorsa T, "Matrix metalloproteinases(MMPs) in oral disease", Oral Disease, 10, pp.311~318 (2004)
- Hebling J, "Chlorhexidine arrests subclinical degradation of dentin hybrid layers in vivo", J Dent Res, 84, pp.741~746 (2005)
- Carrilho MR, "Chlorhexidine preserves dentin bond in vitro", J Dent Res, 86, pp.90~94 (2007)
- Carrilho MR, "Mechnical stability of resin- dentin bond components", Dent Mater, 21, pp.232~241 (2005)
- Carrilho MR, "Durability of resin-dentin bonds related to water and oil storage", Am J Dent, 18, pp.315~319 (2005)
- De Castro F, "Effect of 2% chlorhexidine on microtensile bond strength of composite to dentin", J Adhes Dent, 5, pp.129~138 (2003)
- Martin-De Las Heras S, "The matrix metalloproteinases gelatinases A in human dentin", Arch Oral Biology, 45, pp.757~765 (2000)
- De Munck J, "A critical review of the durability of adhesion to tooth tissue: methods and results", J Dent Res, 84, pp.118~132 (2005)
- Nagase H, "Structure and function of matrix metalloproteinases and TIMPs", Cardiovascular Res, 69, pp.562~573 (2006)
- Nishitani Y, "Activation of gelatinolytic", collagenolytic activity in dentin by selfetching adhesives, 2006, pp.114, 160~166
- Dumas J, "Collagenases in mineralized tissues of human teeth", FEBS Lett, 187, pp.51~55 (1985)
- Sulkala M, "The effects of MMP inhibitors on human salivary MMP activity and caries progression in rat", J Dent Res, 80, pp.1545~1549 (2001)
- Traderhane L, "The activation and function of host matrix metalloproteinases in dentin matrix breakdown in caries lesions", J Dent Res, 77, pp.1622~1629 (1998)
- Van Strijp AJ, "Bacterial colonization and degradation of demineralized dentin matrix in situ", Caries Res, 28, pp.21~27 (1994)
- Van Strijp AJ, "Bacterial colonization of mineralized and completely demineralized dentin in situ", Caries Res, 31, pp.349~355 (1997)
- Birkedal-Hansen H, "Matrix metalloproteinases: a review", Crit Rev Oral Biol Med, 4, pp.197~250 (1993)
- Bode W, "Structural properties of matrix metalloproteinases", Cell Mol Life Sci, 55, pp.639~652 (1999)
- Van Strijp AJ, "Host-derived proteinases and degradation of dentine collagen in situ", Caries Res, 37, pp.58~65 (2003)
- Brackett WW, "The effect of chlorhexidine on dentin hybrid layers in vivo", Oper Dent, 32, pp.107~111 (2007)
- Carrilho MR, "In vivo preservation of the hybrid layer by chlorhexidine", J Dent Res, 86, pp.529~533 (2007)
- Inoue S, "Effect of remaining dentin thickness and the use of conditioner on microtensile bond strength of glass ionomer adhesive", Dent Mater, 17, pp.445~455 (2001)
- Lin A, "Studies on the adhesion of glass ionomer cements to dentin", J Dent Res, 71, pp.1836~1841 (1992)
- Van Meerbeek B, "Adhesives and cements to promote preservation dentistry", Oper Dent, 26, pp.S119~S144 (2001)
- Yoshida Y, "Evidence of chemical bonding at biomaterial-hard tissue interfaces", J Dent Res, 79, pp.709~714 (2000)
- Gale MS, "Thermal cycling procedures for laboratory testing of dental restorations", J Dent, 27, pp.89~99 (1999)
- Van Meerbeek B, "Correlative transmission electron microscopy examination of nondemineralized and demineralized resin-dentin interfaces formed by two dentin adhesive systems", J Dent Res, 75, pp.879~888 (1996)
- Eliades G, "Heterogenous distribution of single-bottle adhesive monomers in the resin-dentin interdiffusion zone", Dent Mater, 17, pp.277~283 (2001)