Visualizing test on the pass-through and collision characteristics of coarse particles in a double blade pump
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
As the key equipment in deep ocean mining, the slurry pump suffers from wear and blocking problems. In this paper, high-speed photography technique is applied to track the movement rule of single particle of the coarse particle solideliquid two-phase flow in a double blade slurry pump. The influences of particle diameter and particle density on the pass-through and collision characteristics of particles are analyzed as well. The results show that the average of the passing pump time first decreases and then increases when the particle diameter increases. The average of the passing pump time decreases by 22.7%, when the particle density increases from 1.09 g/cm3 to 1.75 g/cm3. Besides, the particle density has great influence on the location where the particle hits the tongue. Most particles of 1.09 g/cm3 hit the tongue on the left side, while collision location of particles of 1.75 g/cm3 is mainly on the top and at the right side of the tongue. The research can provide a basis for the optimization design of slurry pump in deep ocean mining system.
Abstract
As the key equipment in deep ocean mining, the slurry pump suffers from wear and blocking problems. In this paper, high-speed photography technique is applied to track the movement rule of single particle of the coarse particle solideliquid two-phase flow in a double blade slurry pump. The influences of particle diameter and particle density on the pass-through and collision characteristics of particles are analyzed as well. The results show that the average of the passing pump time first decreases and then increases when the particle diameter increases. The average of the passing pump time decreases by 22.7%, when the particle density increases from 1.09 g/cm3 to 1.75 g/cm3. Besides, the particle density has great influence on the location where the particle hits the tongue. Most particles of 1.09 g/cm3 hit the tongue on the left side, while collision location of particles of 1.75 g/cm3 is mainly on the top and at the right side of the tongue. The research can provide a basis for the optimization design of slurry pump in deep ocean mining system.
참고문헌 (11)
- Adewumi, M.A., "Possible detection of multiple blockages using transients", J. Energy Resour. Technol., 125(2), pp.154~159 (2003)[DOI]
- Bartosik, A., "Influence of coarse-dispersive solid phase on the 'particleswall ' shear stress in turbulent slurry flow with high solid concentration", Arch. Mech. Eng., 57(1), pp.45~68 (2010)
- Duan, H.F., "Extended blockage detection in pipelines by using the system frequency response analysis", J. Water Resour. Plan. Manag., 138(1), pp.55~62 (2012)[DOI]
- Gidaspow, D., "Multiphase Flow and Fluidization: Continuum and Kinetic Theory Descriptions" (1994), Academic press
- Han, W.L., "Water hammer in coarse-grained solid-liquid flows in hydraulic hoisting for ocean mining", Trans. Nonferrous Metals Soc. China, 12(3), pp.508~513 (2002)
- Ma, J., "Practical considerations of sludge and blockage detection inside pipes using guided ultrasonic waves", Am. Inst. Phys., 894, pp.136~143 (2007)
- Wijk, J.M., "Flow assurance of vertical solid-liquid two phase riser flow during deep sea mining", Offshore Technology Conference (2012)
- Walker, C.I., "Comparison of some laboratory wear tests and field wear in slurry pumps", Wear, 302(1), pp.1026~1034 (2013)[DOI]
- Xiao, L.J., "Advance and present state of the research in oceanic metalliferous nodule mining", Metal Mine (2000)
- Xia, J.X., "Hydraulic lifting of manganese nodules through a riser", J. Offshore Mech. Arct. Eng., 126(1), pp.72~77 (2004)[DOI]
- Zou, W.S., "China's study on the lift system in deep ocean mining", Proceedings of the 17th International Conference on the Hydraulic Transport of Solids (2007)