공명기의 위상 지연을 활용한 음향 메타물질의 음파 전달 특성
Wave Transmission Characteristics of Acoustic Metamaterials using Phase Delay of Resonators
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
Research has been conducted on acoustic metamaterials that control the transmission characteristics of reflected and refracted waves using phase delay by resonators. Using one-dimensional theory, the phase delay equations for the 1/4 wavelength and Helmholtz resonator are presented. These one-dimensional analysis results are compared with the results predicted by three-dimensional FEM. The advantages and disadvantages of 1/4 wavelength and Helmholtz resonator were confirmed in implementing phase delay. An acoustic metamaterial with a refraction angle of 30° was manufactured using multiple tubes and then the sound pressure distribution was measured. A relatively large sound pressure was measured at the target position of 30°, which was compared with the 3D FEM analysis results. Simulations confirmed that a phase delay range closer to 2π was more effective in refraction, but varying the number of resonators was found to have minimal impact on which additional research is needed for generalization.
Abstract
Research has been conducted on acoustic metamaterials that control the transmission characteristics of reflected and refracted waves using phase delay by resonators. Using one-dimensional theory, the phase delay equations for the 1/4 wavelength and Helmholtz resonator are presented. These one-dimensional analysis results are compared with the results predicted by three-dimensional FEM. The advantages and disadvantages of 1/4 wavelength and Helmholtz resonator were confirmed in implementing phase delay. An acoustic metamaterial with a refraction angle of 30° was manufactured using multiple tubes and then the sound pressure distribution was measured. A relatively large sound pressure was measured at the target position of 30°, which was compared with the 3D FEM analysis results. Simulations confirmed that a phase delay range closer to 2π was more effective in refraction, but varying the number of resonators was found to have minimal impact on which additional research is needed for generalization.
참고문헌 (15)
- Zangeneh-Nejad, F., "Active times for acoustic metamaterials", Reviews in Physics, 4, pp.100031~ (2019)
- Guo, J., "A phase-gradient acoustic metasurface for broadband duct noise attenuation in the presence of flow", International Journal of Mechanical Science, 237, pp.107822~ (2023)
- Ding, C. L., "Experimental realization of acoustic metasurface with double-split hollow sphere", Solid State communications, 229, pp.28~31 (2016)
- Kim, H. S., "Acoustic metamaterial design by phase delay derivation using transfer matrix, Symmetry", Symmetry, 15, pp.689~ (2023)
- Ge, Y., "Switchable omnidirectional acoustic insulation through open window structures with ultrathin metasurfaces", Phys Review Materials, 3, pp.065203~ (2019)
- Zhang, H. L., "Sound insulation in a hollow pipe with subwavelength thickness", Scientific Reports, 7, pp.44106~ (2017)
- Zhu, Y. F., "Acoustic one-way open tunnel by using metasurface", Applied Physics Letters, 107, pp.113501~ (2015)
- Han, D. -Y., "Tunable pipe-type acoustic metamaterials based on piezoelectric composite sidebranches", Jounral of Applied Physics, 129, pp.084505~ (2021)
- Jinag, X., "Acoustic one-way metasurface : Asymmetric phase modulation of sound by subwavelength layer", Scientific Reports, 6, pp.28023~ (2016)
- Li, X. -Y., "Broadband acoustic phased array with subwavelength active tube array", Applied Physics Letters, 112, pp.093503~ (2018)
- Kwon, B. J., "Wave propagation characteristics of acoustic metamaterials with Helmholtz resonator", Transaction of KSNVE, 23(2), pp.167~175 (2013)
- Kim, D. Y., "Virtual Herschel-Quincke tube using the multiple small resonators and acoustic metamaterials", Journal of Sound and Vibration, 466, pp.115045~ (2020)
- Kim, M. H., "Improvement of noise attenuation performance of a multi-layer panel by using acoustic metamaterial", Trans. Korean Soc. Meeh. Eng. A, 43(4), pp.287~295 (2019)
- "ASTM E2611-19, 2019, Standard test method for normal incidence determination of porous material acoustical properties based on the transfer matrix Method", ~ (2019)