라텍스개질 콘크리트의(LMC)의 강도특성 및 배합인자 결정방법
Strength Properties and Determination Method of Mix Proportion Factor of Latex Modified Concrete
0
조회
0
다운로드
5
인용
0
참고문헌
키워드
초록
This study are decided the mix proportion method of latex modified concrete for agricultural concrete structures from the results of workability and strength test with mix proportion factor. For mix proportion factor, this study are selected the water-cement ratio, unit cement amount and latex content. Also, this study were performed the slump, compressive strength test and microstructure analysis using the scanning electron microscope(SEM). The strength and slump of LMC are dependent with unit cement amount, latex content, and water-cement ratio. Especially, the strength of LMC are not controlled by single mix proportion factor but effected by combined mix proportion factor. Microstructure investigation are showed the LMC are reduced the internal pore volume and enhanced the transition zone between cement paste and aggregate interface. This effect get by consist of latex films in the concrete. Also, this study were recommended the mix proportion method for LMC. These mix proportions method are estimated the mix design for satisfied the target performance which are applied the agricultural concrete structure.
Abstract
This study are decided the mix proportion method of latex modified concrete for agricultural concrete structures from the results of workability and strength test with mix proportion factor. For mix proportion factor, this study are selected the water-cement ratio, unit cement amount and latex content. Also, this study were performed the slump, compressive strength test and microstructure analysis using the scanning electron microscope(SEM). The strength and slump of LMC are dependent with unit cement amount, latex content, and water-cement ratio. Especially, the strength of LMC are not controlled by single mix proportion factor but effected by combined mix proportion factor. Microstructure investigation are showed the LMC are reduced the internal pore volume and enhanced the transition zone between cement paste and aggregate interface. This effect get by consist of latex films in the concrete. Also, this study were recommended the mix proportion method for LMC. These mix proportions method are estimated the mix design for satisfied the target performance which are applied the agricultural concrete structure.
참고문헌 (16)
- Adnan C., "Properties of plain and latex modified portland cement pastes and concretes with and without superplasticizer", Cement and Concrete Research, 35(8), pp.1510~1521 (2005)
- Barluenga, G, "SBR latex modified mortar rheology and mechanical behavior", Journal of Cement and Concrete Research, 34(3), pp.527~535 (2003)
- Biswas, M., "Effect of latex and superplasticizer on portland cement mortar in the fresh state", Journal of Cement and Concrete Composites, 16(4), pp.309~316 (1994)
- Chandra, S., "Polymers in Concrete" (1994), CRC Press
- Leo M. Saija, "Waterproofing of portland cement mortars with a specially designed polyacrylic latex", Journal of Cement of Concrete Research, 25(3), pp.503~509 (1994)
- "Ministry of Agriculture and Forestry, 2000, Development of system for optimum design, safety appraisal and repair works on agricultural structures.(in Korean)", ~ (2000)
- "Ministry of Agriculture and Forestry, 1999, Guideline for repair method of hydraulic structures.(in Korea)", ~ (1999)
- "Ministry of Agriculture and Forestry, 1991, Agricultural civil engineering hand book.(in Korean)", ~ (1991)
- "Ministry of Agriculture and Forestry, 2005, Study on a scheme of rearranging technologies for repairing & reinforcing irrigation & drainage structure damaged or deteriorated.(in Korean)" (2005)
- "NCHRP Synthesis 179, 1992, Latex-modified concretes and mortars, Transportation Research Board, National Research Council, Washington, D.C., U.S.A", ~ (1992)
- Ohama, Y., "Handbook of polymer-modified concrete and mortars properties and process technology" (1995), Noyes Publications
- Ohama, Y., "Mix design system for polymer-modified mortar", Proceedings, Second Australian Conference on Engineering Materials, pp.163~170 (1981), The University of New South Wales
- Ohama, Y., "Proposed mix proportioning of polymer-modified concrete, polymers in concrete", Third International Congress on Polymers in Concrete, pp.309~332 (1981)
- Soroushin, P., "Latex modified concrete; state of the art, MSU-ENGR-88-012, Michigan State University, East Lunsing, Michigan 48824", ~ (1998)
- Won, J.P., "Shrinkage and durability characteristics of latex modified repair mortar for agricultural concrete structures", KSAE, 49(5), pp.23~30 (2007)
- Won, J-P., "Optimum mix proportion of latex modified repair mortar for agricultural concrete structures", KSAE, 49(2), pp.37~46 (2007)