유빙 및 평탄빙의 충돌에 의한 빙하중과 선체구조응답 해석기법
Analysis Method of Ice Load and Ship Structural Response due to Collision of Ice Bergy Bit and Level Ice
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
The most important factor in the structural design of ships and offshore structures operating in arctic region is ice load, which results from ice-structure interaction during the ice collision process. The mechanical properties of ice related to strength and failure, however, show very complicated aspect varying with temperature, volume fraction of brine, grain size, strain rate and etc. So it is nearly impossible to establish a perfect material model of ice satisfying all the mechanical characteristics completely. Therefore, in general, ice collision analysis was carried out by relatively simple material models considering only specific aspects of mechanical characteristics of ice and it would be the most significant cause of inevitable errors in the analysis. Especially, it is well-known that the most distinctive mechanical property of ice is high dependency on strain rate. Ice shows brittle attribute in higher strain rate while it becomes ductile in lower strain rate range. In this study, the simulation method of ice collision to ship hull using the nonlinear dynamic FE analysis was dealt with. To consider the strain rate effects of ice during ice-structural interaction, strain rate dependent constitutive model in which yield stress and hardening behaviors vary with strain rate was adopted. To reduce the huge amount of computing time, the modeling range of ice and ship structure were restricted to the confined region of interest. Under the various scenario of ice-ship hull collision, the structural behavior of hull panels and failure modes of ice were examined by nonlinear FE analysis technique.
Abstract
The most important factor in the structural design of ships and offshore structures operating in arctic region is ice load, which results from ice-structure interaction during the ice collision process. The mechanical properties of ice related to strength and failure, however, show very complicated aspect varying with temperature, volume fraction of brine, grain size, strain rate and etc. So it is nearly impossible to establish a perfect material model of ice satisfying all the mechanical characteristics completely. Therefore, in general, ice collision analysis was carried out by relatively simple material models considering only specific aspects of mechanical characteristics of ice and it would be the most significant cause of inevitable errors in the analysis. Especially, it is well-known that the most distinctive mechanical property of ice is high dependency on strain rate. Ice shows brittle attribute in higher strain rate while it becomes ductile in lower strain rate range. In this study, the simulation method of ice collision to ship hull using the nonlinear dynamic FE analysis was dealt with. To consider the strain rate effects of ice during ice-structural interaction, strain rate dependent constitutive model in which yield stress and hardening behaviors vary with strain rate was adopted. To reduce the huge amount of computing time, the modeling range of ice and ship structure were restricted to the confined region of interest. Under the various scenario of ice-ship hull collision, the structural behavior of hull panels and failure modes of ice were examined by nonlinear FE analysis technique.
참고문헌 (13)
- Bishop, R., "Hydroelasticity of Ships" (1979), Cambridge University Press
- Carney, Kelly S., "A Phenomenological High Strain Rate Model with Failure for Ice", International Journal of Solids and Structures, 43, pp.7820~7839 (2006)
- Derradji-Aouat, A., "Mathematical Modelling of Monotonic and Behaviour of Fresh Water Columnar Grained S-2 Ice", Cold Regions Science and Technology, 31, pp.59~81 (2000)
- Iceberg Collision Scenario, "DNV", ~, pp.Det Norske Veritas Report, Report No. : 2006-0672 (2006)
- Han, S.K., "Structure risk analysis of a GTT NO96 membrane type LNG carrier in baltic ice operations", Proceedings of IMechE 2008, 222(4), pp.179~192 (2008), Institution of Mechanical Engineers
- Comparison of the Strength of Iceberg and Other Freshwater Ice and the Effect of Temperature, "Jones, S.", NRC, ~, pp.PERD (2006), CHC Report 20-83 TR-2006-07
- Kolari, K., "FE-simulation of continuous ice failure based on model update technique", Proceedings of the 20th International Conference on Port and Ocean Engineering under Arctic Conditions (2009)
- Increasing the Safety of Icebound Shipping, "Kujala, P.", Helsinki University of Technology, Ship Laboratory, ~, pp.Final Scientific Report:Volume 1
- Increasing the Safety of Icebound Shipping, "Kujala, P.", Helsinki University of Technology, Ship Laboratory, ~, pp.Final Scientific Report:Volume 2 (2007)
- Lee, S.G., "Development of full scale iceberg-membrane type LNG carrier collision simulation technique", Proceeding of the Annual Spring Meeting, the Society of Naval Architecture of Korea, pp.1263~1304 (2009)
- LSTC, "2007 LS-DYNA Keyword User’s Manual, volume1, Version 971", ~ (2007)
- 노인식, "빙 충돌에 대한 Mark III 멤브레인형 LNG CCS의 구조 안전성 평가", 한국해양공학회지, 28(2), pp.126~132 (2014), 한국해양공학회
- Wang, Y. S., "A Rate-Dependent stress-strain relationship for sea ice", Proceedings of the 1st International Offshore Mechanics and Arctic Engineering Symposium, 2 (1982)