본문 바로가기
KERD
논문KCI 등재

치면열구전색제의 표면처리와 중합시간 증가에 따른 미반응 모노머 용리 평가

Monomer release from pit and fissure sealant following by surface treatment and curing time

0

조회

0

다운로드

1

인용

0

참고문헌

키워드

주제분류치의학

초록

본 연구는 복합 레진의 중합률에 영향을 미치는 광조사 시간을 달리하여 치면열구전색제를 중합하였을 경우 이로부터 용리되는 미반응 모노머들을 확인하고 정량화하고자 하였다. 그리고 치면열구전색제 중합 후 표면에 나타나는 미반응 모노머 층을 다양한 방법으로 제거한 후 용리되는 미반응 모노머들을 정량분석함으로써 미반응 모노머의 제거효과를 비교 평가하고자 하였다. 광중합 시간에 따라 각각 20초, 40초, 60초간 중합한 후, 중합시간 별로 어떠한 처리도 시행하지 않은 군을 대조군, 증류수로 10초간 세척한 군을 I군(Group I), 75% 알콜에 젖은 면구로 10초간 문지른 군을 II군(Group II), 퍼미스와 러버컵을 이용하여 10초간 처리하고 증류수로 가볍게 세척한 군을 III군(Group III)으로 분류하였다. 표면처리 후 각 시편을 3차 증류수에 넣고 37℃ 항온 수조에서 10분간 보관한 후 각각의 용리액을 고성능 액체 크로마토그래피를 이용하여 정성 및 정량 분석을 시행하였고 다음과 같은 결과를 얻었다. 1. 모든 대조군과 실험군에서 TEGDMA를 제외한 어떠한 모노머들도 검출되지 않았다. 2. 최소 중합시간, 권장 중합시간, 권장 중합시간 이상의 순으로 중합시간이 증가할수록 TEGDMA의 용리량은 감소하였다. 3. 표면처리를 한 군들은 대조군에 비하여 TEGDMA의 용리량이 유의할 만하게 감소하였다. 4. 표면처리를 한 군 가운데 퍼미스와 러버컵을 이용한 경우 잔존 모노머의 제거 효과가 다른 군에 비하여 유의성 있게 높았다. 5. 권장 중합시간 이상인 60초 중합 후, 퍼미스와 러버컵을 이용하여 표면처리한 경우 가장 적은 양의 모노머 용리량을 보였다.

Abstract

The purpose of this study was to evaluate the effects of a various light curing time on the residual monomers released from light-cured dental sealant, and to examine the effectiveness of surface treatment in reducing the oxygen-inhibited layer of light-cured dental sealant(Helioseal. F, Vivadent, Liechtenstein). Specimens were cured with a halogen light curing unit(XL 3000, 3M, USA) for 20, 40, 60s. Surface treatment of a light-cured dental sealant included no treatment(control group), a 10-seconds exposure to distilled water(Group I), 10-seconds manual application using a cotton pellet wetted with 75% alcohol(Group II), and 10-seconds application of a water/pumice slurry using a rubber cup on a slow-speed handpiece. The specimens were eluted in distilled water for 10 minutes. All elutes were analyzed by HPLC for identification and quantitive analysis of monomers. The results of this study can be summarized as follows. 1. None of the chromatograms of the tested sealant displayed peaks with the same retention time as that of the standard solution, except for TEGDMA. 2. The release of TEGDMA decreased with increasing curing time in conventional halogen light. 3. All surface treatment group had a decrease of monomer release in comparison with no treatment group. 4. Treatment that Group III eliminated the greatest amount of any type of residual monomers. 5. The elution of unreacted monomers from curing with halogen curing unit for 60s and Group III was less than other groups.

참고문헌 (42)

  1. "Minimizing patients’exposure to uncured components in a dental sealant", 130, pp.1751~1757 (1999)
  2. "A study of component release from resin pit and fissure sealants in vitro", 13, pp.98~102 (1997)
  3. "Determination of residual monomers in dental pit and fissure sealants using food", oral simulation fluids, 2000, pp.21, 1115~1118
  4. "Elution of TEGDMA and BisGMA from a resin and a resin composite cured with halogen or plasma light", 108, pp.341~345 (2000)
  5. "Light-activated restorative materials : a method of determining effective radiation times", 23, pp.210~218 (1996)
  6. "광원에 따른 조사거리의 증가가 복합레진의 중합도에 미치는 영향", 31, pp.273~279 (2004)
  7. "Characterization of resin composites polymerized with plasma arc curing units", 16, pp.330~336 (2000)
  8. "Depth of cure and compressive strength of dental composites cured with blue light emitting diodes (LEDs)", 16, pp.41~47 (2000)
  9. "Light emitting diode (LED) polymerisation of dental composites : flexural properties and polymerisation potential", 21, pp.1379~1385 (2000)
  10. "In vitro elution of leachable components from dental sealants", 128, pp.1517~1523 (1997)
  11. "Bioavailability of components of resin-based materials which are applied to teeth", 7, pp.172~170 (1996)
  12. "Cytotoxic effects of resin components on cultured mammalian fibroblast", 70, pp.1450~1455 (1991)
  13. "Cytotoxicity of components of resins and other dental restorative materials", 21, pp.453~462 (1994)
  14. "Variability of cytotoxicity and leaching of substances from four light-curing pit and fissure sealants", 44, pp.73~77 (1998)
  15. "Cytotoxic effects of dental composites, adhesive substances, compomers and cements", 14, pp.429~440 (1998)
  16. "Effects of dental restorative materials:local and systemic responses reviewed", 124, pp.76~80 (1993)
  17. "Adverse reaction to a fissure sealant report of a case", pp.143~146 (1993)
  18. "A delayed hypersensitivity reaction to dentin primer in the guinea-pig", 23, pp.295~300 (1995)
  19. "Oral lichenoid reactions related to composite restoration", 46, pp.63~65 (1988)
  20. "Delayed extraoral hypresensitivity to dental composite material", 47, pp.329~333 (1979)
  21. "Allergic contact to bisphenol-A glycidyl dimethacrylate(BISGMA) dental resin associated with senitivity to epoxy resin", 183, pp.297~298 (1997)
  22. "Estrogenicity of resin-based composites and sealants used in dentistry", 104, pp.298~305 (1996)
  23. "Unpolymerized surface layers on sealants", 39, pp.27~32 (1981)
  24. "Cytotoxicity of urethane dimethacrylate composites before and after aging and leaching", 124, pp.76~80 (1998)
  25. "Elution of leachable components from composites", 21, pp.441~452 (1994)
  26. "Identification and characterization of estrogen-like components in commercial resin-based dental restorative materials", 3, pp.107~113 (1999)
  27. "Pharmacokinetics of bisphenol A released from a dental sealant", 131, pp.51~58 (2000)
  28. "Effects of unpolymerized resin components on the function of accessory cells derived from the rat incisor pulp", 74, pp.1162~1167 (1995)
  29. "Cytotoxicity of 35 dental resin composite monomers", additives in permanent 3T3 and three human primary fibroblast cultures, 1998, pp.41, 474~480
  30. "TEGDMA-induced toxicity in human fibroblasts is associated with early and drastic glutathione depletion with subsequent production of oxygen reactive species", 66, pp.476~482 (2003)
  31. "The effect of curing light intensity and test temperature on the dynamic mechanical properties of two polymer composites", 26, pp.635~639 (1999)
  32. "Effect of compositional change of composite resin on mechanical properties", 16, pp.185~ (1989)
  33. "Effect of light wavelength on polymerization of light-cured resins", 16, pp.60~73 (1997)
  34. "Effect of light exposure on fracture toughness and flexural strength of light cured composite", 12, pp.328~332 (1996)
  35. "Effect of power density of curing unit, exposure duration, and light guide distance on composite depth of cure", 9, pp.71~76 (2005)
  36. "Effect of curing method and curing time on the microhardness and wear of pit and fissure sealants", 18, pp.120~127 (2002)
  37. "The effect of irradiation time on the physical properties of lightcured resins", 6, pp.21~28 (1990)
  38. "Halogen lamp 광조사기와 Plasma xenon arc lamp 광조사기에 의한 광중합 복합레진의 중합률 비교", 29, pp.328~336 (2002)
  39. "The influence of surface loading and irradiation time during on mechanical properties of a composite", 77, pp.573~577 (1997)
  40. "Effect of light intensity and exposure duration on cure of resin composite", pp.26~32 (1994)
  41. "Influences of chemical on wear of dental composites", 61, pp.1180~1183 (1982)
  42. "Rate of elution of leachable components from composites", 6, pp.282~287 (1990)

이 간행물의 다른 논문 (19건)