본문 바로가기
KERD
논문KCI 등재

Off-road 엔진의 EGR율에 따른 촉매코팅 DPF의 자연재생율 예측

Predicting the Oxidation Amount in the Catalyzed DPF according to the EGR Rate for the Off-road Engine

1

조회

0

다운로드

0

인용

0

참고문헌

키워드

초록

This paper aims to predict oxidation amounts of catalyst and heat produced through passive regeneration on DPF according to different EGR rates and loads of off-road engines. Soot oxidation model and parameter assumption model were used for the test. Engine data were measureed with 25%, 50% and 75% of 1600 RPM loads and with 0% and 30% of EGR rates in order to estimate parameters. Oxygen levels calculated on the DPF downstream and oxygen levels measured were compared through all of the experimental conditions for validating the model. Oxidation rates on DPF according to different EGR rates and oxygen levels on the DPF downstream were estimateed successfully, which can be applied for off-road vehicles.

Abstract

This paper aims to predict oxidation amounts of catalyst and heat produced through passive regeneration on DPF according to different EGR rates and loads of off-road engines. Soot oxidation model and parameter assumption model were used for the test. Engine data were measureed with 25%, 50% and 75% of 1600 RPM loads and with 0% and 30% of EGR rates in order to estimate parameters. Oxygen levels calculated on the DPF downstream and oxygen levels measured were compared through all of the experimental conditions for validating the model. Oxidation rates on DPF according to different EGR rates and oxygen levels on the DPF downstream were estimateed successfully, which can be applied for off-road vehicles.

참고문헌 (8)

  1. Youngjin Cho, "Development of DPF system for Tier4diesel engine", KSAE Spring Conference Proceedings, pp.336~340 (2012)
  2. McCarthy Jr, J., "Meeting Nonroad Final Tier 4 Emissions on a 404 John Deere Engine Using A Fuel Reformer and LNT System with An Optional SCR Showing Transparent Vehicle Operation, Vehicle Packaging and Compliance to End-of-Life Emissions", SAE Int. J. Engines, 4(3), pp.2699~2717 (2011)
  3. Khan, M. R., "A Numerical Investigation of the Regeneration Characteristics of Diesel Particulate Filters under Simulated Transient Exhaust Conditions", Proc. IMechE Part D:Journal of Automobile Engineering, 222(12), pp.2469~2485 (2008)
  4. A Study of the Filtration and Oxidation Characteristics of a Diesel Oxidation Catalyst and a Catalyzed Particulate Filter, "Premchand, K.", SAE, ~, pp.SAE Technical Paper Series, 2007-01-1123 (2007)
  5. Fundamental Studies of Diesel Particulate Filters: Transient Loading, Regeneration and Aging, "Konstandopoulos, A.", SAE, ~, pp.SAE Technical Paper Series, 2000-01-1016 (2000)
  6. A Methodology to Estimate the Mass of Particulate Matter Retained in a Catalyzed Particulate Filter as Applied to Active Regeneration and On-Board Diagnostics to Detect Filter Failures, "Dabhoiwala, R.", SAE, ~, pp.SAE Technical Paper Series, 2008-01-0764 (2008)
  7. An Advanced 1D 2-Layer Catalyzed Diesel Particulate Filter Model to Simulate: Filtration by the Wall and Particulate Cake, Oxidation in the Wall and Particulate Cake by NO2 and O2, and Regeneration by Heat Addition, "Mohammed, H.", SAE, ~, pp.SAE Technical Paper Series, 2006-01-0467 (2006)
  8. Progress in Diesel Particulate Filter Simulation, "Konstandopoulos, A.", SAE, ~, pp.SAE Technical Paper Series, 2005-01-0946 (2005)

관련 논문AI추천

이 간행물의 다른 논문 (4건)