희박 예혼합 저선회 연소기에서 화염부상높이에 관한 고찰
A Study on the Flame Liftoff Height in a Lean-Premixed Low Swirl Combustor
2
조회
0
다운로드
7
인용
0
참고문헌
키워드
초록
Experiments were carried out to study the flame liftoff height(FLH) and flame stabilization at the fuel-lean region in CH4/Air premixed flames of a low-swirl combustor. The burner used in this study had a nozzle diameter of 28 mm, a combustion chamber with an expansion area ratio of 7.0, a swirler with a swirl angle of 37°, and a turbulence generator with a porosity of 28.7%. The experiments were performed for equivalence ratios ranging from 0.53 to 0.8 and inlet velocities from 2.3 to 4.6 m/s. The CH* chemiluminescence images were acquired using ICCD camera to measure the FLH. As a result, at the equivalent ratios ranging from 0.8 to 0.6, the FLH increased as the equivalence ratio decreased, which is reasonable as the laminar flame speed decreases along with the decreasing equivalence ratio. At equivalence ratios smaller than 0.6, however, the FLH was reduced despite the reduction in equivalent ratio. At the same equivalent ratio, the FLH decreased at elevated inlet velocities, which was again counterintuitive. According to the results with the absence of a chamber wall, the flame stabilization was observed to be highly dependent on the existence of the outer recirculation zone.
Abstract
Experiments were carried out to study the flame liftoff height(FLH) and flame stabilization at the fuel-lean region in CH4/Air premixed flames of a low-swirl combustor. The burner used in this study had a nozzle diameter of 28 mm, a combustion chamber with an expansion area ratio of 7.0, a swirler with a swirl angle of 37°, and a turbulence generator with a porosity of 28.7%. The experiments were performed for equivalence ratios ranging from 0.53 to 0.8 and inlet velocities from 2.3 to 4.6 m/s. The CH* chemiluminescence images were acquired using ICCD camera to measure the FLH. As a result, at the equivalent ratios ranging from 0.8 to 0.6, the FLH increased as the equivalence ratio decreased, which is reasonable as the laminar flame speed decreases along with the decreasing equivalence ratio. At equivalence ratios smaller than 0.6, however, the FLH was reduced despite the reduction in equivalent ratio. At the same equivalent ratio, the FLH decreased at elevated inlet velocities, which was again counterintuitive. According to the results with the absence of a chamber wall, the flame stabilization was observed to be highly dependent on the existence of the outer recirculation zone.
참고문헌 (22)
- 이지호, "희박 예혼합 모델 가스터빈 연소기에서 스월유동 특성이 화염 간 상호작용에 미치는 영향", 한국연소학회지, 23(1), pp.21~27 (2018), 한국연소학회[DOI]
- 손진우, "화염 전달함수 및 DMD 기법을 이용한 모형 가스터빈의 연소불안정성 평가", 한국연소학회지, 22(2), pp.1~8 (2017), 한국연소학회[DOI]
- 장문석, "연소실 길이에 따른 이중선회 가스터빈 모델 연소기에서 연소불안정 모드 연구", 한국연소학회지, 21(2), pp.29~37 (2016), 한국연소학회[DOI]
- 김택현, "동축 반전 스월러의 플레어 각도변화가 스월러 유동에 미치는 영향 연구", 한국연소학회지, 21(1), pp.31~37 (2016), 한국연소학회[DOI]
- R.K. Cheng, "Velocity and Scalar Characteristics of Premixed Turbulent Flames Stabilized by Weak Swirl", Combust. Flame., 101, pp.1~14 (1995)
- R.K. Cheng, "Development of a Vane-Swirler for Use in a Low NOx Weak-Swirl Burner", American Flame Research Committee International Symposium (1996)
- R.K. Cheng, "Scaling and Development of Low-Swirl Burners Low Emission Furnaces and Boilers", Proceedings of the Combustion Institute, 28, pp.1305~1313 (2000)
- T. Plessing, "Measurements of the Turbulent Burning Velocity and the Structure of Premixed Flames on a Low-Swirl Burner", Proceedings of the Combustion Institute, 28(1), pp.359~366 (2000)
- R.K. Cheng, "Development of a Low Swirl Injector Concept for Gas Turbines", 2001 International Joint Power Conference, pp.95~101 (2001)
- M.R. Johnson, "A Comparison of the Flow fields and Emission of High-Swirl Injectors and Low-Swirl Injectors for Lean Premixed Gas Turbines", Proceedings of the Combustion Institute, 30(2), pp.2867~2874 (2005)
- Y. Deng, "Combustion and Exhaust Emission Characteristics of Low Swirl Injector", Appl. Therm. Eng., 110, pp.171~180 (2017)
- R.K. Cheng, "Laboratory Studies of the Field Characteristics of Low-Swirl Injectors for Adaptation to Fuel-Flexible Turbines", J. Eng. Gas Turb. Power, 130(2), pp.277~285 (2006)
- G.E. Ballachey, "Prediction of Blowoff in a Fully Controllable Low-Swirl Burner Burning Alternative Fuels: Effects of Burner Geometry, Swirl, and Fuel Composition", Proceeding of the Combustion Institute, 34, pp.3193~3201 (2013)
- Development of an Active Grid Adapted to a Low-Swirl Burner and Measurements of Turbulent Properties of the Flow Field, JAXA Research and Development Report, JAXA-RR-05-055E, "I. Jeon", ~ (2006)
- 강성모, "저 스월 버너에서의 난류 예혼합 부상화염장의 해석", 한국연소학회지, 12(3), pp.8~15 (2007), 한국연소학회
- 정황희, "저선회 모델 연소기의 연소특성 및 선회각도 영향", 한국추진공학회지, 20(4), pp.40~49 (2016), 한국추진공학회
- 정황희, "저선회 연소기에서 합성천연가스(SNG) 연료의 수소함량에 따른 연소 특성 연구", 한국수소및신에너지학회논문집, 28(2), pp.181~189 (2017), 한국수소및신에너지학회[DOI]
- A.A. Verbeek, "Fractal Turbulence Enhancing Low-Swirl Combustion", Combust. Flame, 162(1), pp.123~143 (2015)
- 정황희, "An experimental study on the effect of a turbulence generating plate in low swirl combustor", Journal of Mechanical Science and Technology, 31(12), pp.6077~6084 (2017), 대한기계학회
- S.R. Turns, "An Introduction to Combustion Concepts and Applications 3rd edition" (2012), McGraw-Hill
- "GRI-mech 3.0"[URL]
- M. Day, "A Combined Computational and Experimental Characterization of Lean Premixed Turbulent Low Swirl Laboratory Flames: I. Methane Flames", Combust. Flame., 159(1), pp.275~290 (2012)