예혼합 화염후류에서 열전달이 CO 및 NOx 생성 특성에 미치는 영향
Effect of Heat Loss on CO and NOx Emission Characteristics in the Postflame Region of Premixed Flames
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
Strict pollutant regulations of NOx emission and increasing awareness of the environmental damage stimulated interest in research to obtain useful information regarding CO and NOx reductions at the same time. In this study, CH4/air premixed flame was examined numerically to reduce CO and NOx emission level simultaneously in the post-flame region by the heat loss models in which radiative and combined conductive and convective heat losses were included. To reduce the NOx emission, first heat exchanger location was decided near the flame. After first heat exchanger was decided for the optimal NOx emission(about 30 ppm), in order to decide the optimal CO emission(about 30ppm), seocond heat exchanger location was tested and decided for several cases. Finally, the optimal location of heat exchanger for minimal CO and NOx emission simultaneously were determined and suggested.
Abstract
Strict pollutant regulations of NOx emission and increasing awareness of the environmental damage stimulated interest in research to obtain useful information regarding CO and NOx reductions at the same time. In this study, CH4/air premixed flame was examined numerically to reduce CO and NOx emission level simultaneously in the post-flame region by the heat loss models in which radiative and combined conductive and convective heat losses were included. To reduce the NOx emission, first heat exchanger location was decided near the flame. After first heat exchanger was decided for the optimal NOx emission(about 30 ppm), in order to decide the optimal CO emission(about 30ppm), seocond heat exchanger location was tested and decided for several cases. Finally, the optimal location of heat exchanger for minimal CO and NOx emission simultaneously were determined and suggested.
참고문헌 (14)
- Lee, C. E., "Numerical and experimental investigations of the NOx emission characteristics of CH4-air coflow jet flames", Fuel, 83, pp.2323~2334 (2004)
- Lefebvre, A. H., "The role of fuel preparation in low emission combustion", ASME J. Eng. Gas Turbine Power, 117, pp.617~654 (1995)
- Bradley, D., "Premixed turbulent instability and NO formation in a lean-burn swirl burner", Combust. Flame, 115, pp.515~538 (1998)
- Kim, J. H., "NOx and CO emission characteristics of premixed oxidizer-staging combustor using a cyclone flow", Journal of Korean Society of Combustion, 13(2), pp.7~13 (2008)
- Ahn, J., "Heat transfer characteristics of 0.5 t", h class non-furnace boiler, 2007, 130~135
- Konnov, A. A., "Probe sampling measurements and modeling of nitric oxide formation in methane-air flames", Combustion Science and Technology, 160, pp.127~1538 (2001)
- Marren, A. Van, "Laser Doppler thermometry in flat flames", Combustion Science and Technology, 99, pp.105~118 (1994)
- Hyun. S. H., "Emission Characteristics of NOx and CO with heat loss under high efficiency combustion conditions of CH4", Air Premixed Flame, 2008, pp.31(1), 1~9
- fortran program for modeling steady laminar one-dimensional premixed flame, "Kee, R. J.", SAND, ~ (1994)
- Tien, C. L., "Thermal radiation properties of gases", Advances in Heat Transfer, 5, pp.253~324 (1968)
- Ju, Y., "On the extinction limit and flammability limit of non-adiabatic stretched methane-air premixed flames", J. Fluid Mechanics, 32, pp.315~334 (1997)
- Kee, R. J., "Chemkin-Ⅱ: A fortran chemical kinetics package for the analysis of gas phase chemical kinetics" (1989), SAND
- A fortran computer code package for the evaluation of gas-phase multi-component transport, "Kee, R. J.", SAND, ~ (1994)
- "GRI Mech. Ver. 2.11, web address:"[URL]