주기패턴 레이더 흡수 구조의 저속충격 후 흡수 성능 평가
Evaluation of the Absorbing Performance of Radar-absorbing Structure with Periodic Pattern after the Low-velocity Impact
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
본 논문에서는 주기패턴 레이더 흡수 구조(RAS)에 다양한 손상을 모사하기 위한 저속충격시험을 수행하고 파손모드에 따른 전자기파 흡수 성능 특성 변화를 평가하였다. 주기패턴 레이더 흡수 구조는 주기패턴시트(PPS) 및 유리섬유강화플라스틱(GFRP)으로 구성되며 설계 및 제작된 구조는 X-band(8.2-12.4 GHz)에서 효과적으로 전자기파를 흡수하였다. 제작된 레이더 흡수 구조에 다양한 손상을 유도하기 위해 충격에너지에 따른 저속충격시험을 수행하였으며, 육안검사, 비파괴 검사 및 이미지 프로세싱을 이용하여 발생한 손상모드 확인 및 손상영역을 정량화하였다. 충격 전, 후 레이더 흡수 구조의 전자기파 흡수 성능은 자유공간 측정 시스템을 이용하여 평가하였다. 시험결과, 15 J의 낮은 충격에너지로 인해 발생한 크기가 작은 층간분리는 레이더 흡수 구조의 전자기파 흡수성능 변화에 큰 영향을 미치지 않았다. 그러나 충격에너지를 40 J 또는 60 J로 증가시켜 상대적으로 넓은 영역의 섬유파손 또는 관통파손이 발생한 구조에서는 전자기파 흡수 성능이 크게 저하되는 것을 확인하였다.
Abstract
In this paper, the microwave absorbing characteristics after the impact of the radar-absorbing structure (RAS) consisting of periodic pattern sheet (PPS) and glass fiber-reinforced plastic (GFRP) were experimentally investigated. The abricated RAS effectively absorbed the microwave in the X-band (8.2-12.4 GHz). In order to induce the damage to the RAS, a low-velocity impact test with various impact energy of 15, 40, and 60 J was conducted. Afterward, the impact damage was observed by using visual inspection, non-destructive test, and image processing method. Moreover, the absorbing performance of intact and damaged RAS was measured by the freespace measurement system. The experiment results revealed that the delamination damage from the impact energy of 15 J did not considerably affect the microwave absorbing performance of the RAS. However, fiber breakage and penetration damage with a relatively large damaged area were occuured when the impact energy was increased up to 40 J and 60 J, and these failures significantly degraded the microwave absorbing characteristics of the RAS.
참고문헌 (27)
- Rao, G. A., "Integrated Review of Stealth Technology and Its Role in Airpower", Aeronautical Journal, 106(1066), pp.629~642 (2002)
- Liu, H. T., "Absorbing Properties of Frequency Selective Surface Absorber with Crossshaped Resistive Patches", Materials and Design, 28(7), pp.2166~2171 (2007)
- Lee, W. J., "Electromagnetic Wave Absorbing Composites with a Square Patterned Conducting Polymer Layer for Wideband Characteristics", Shock and Vibration, 2014, pp.318380~ (2014)
- 장홍규, "섬유강화 복합재료를 이용한 반원통형 전자파 흡수구조의 설계 및 제작", Composites Research, 23(2), pp.17~23 (2010), 한국복합재료학회
- Choi, W. H., "Design of Circuit-Analog(CA)Absorber and Application to the Leading Edge of a Wing-Shaped Structure", IEEE Transaction on Electromagnetic Compatibility, 56(3), pp.599~607 (2014)
- Choi, W. H., "Circuit-analog(CA)Type of Radar Absorbing Composite Leading-edge for Wing-shaped Structure in Xband : Practical Approach from Design to Fabrication", Composites Science and Technology, 105, pp.96~101 (2014)
- Choi, W. H., "A Thin Hybrid Circuit-analog(CA)Microwave Absorbing Double-slab Composite Structure", Composite Structures, 124, pp.310~316 (2015)
- Kim, J. B., "Comparison Study on the Effect of Carbon Nano Materials for Single-layer Microwave Absorbers in X-band", Composites Science and Technology, 68(14), pp.2909~2916 (2008)
- Zou, H., "Determining Factors for High Performance Silicone Rubber Microwave Absorbing Materials", Journal of Magnetism and Magnetic Materials, 323(12), pp.1643~1651 (2011)
- Park, K. Y., "Two-layered Electromagnetic Wave-absorbing E-glass", epoxy Plain Weave Composites Containing Car Nanofibers and NiFe Particles, 2011, pp.45(26), 2773~2781
- Shin, J. H., "Design and Verification of a Single Slab RAS through Mass Production of Glass", MWNT Added Epoxy Composite Prepreg, 2015, pp.132(22), 42019~
- Choi, I., "Radar Absorbing Composite Structures Dispersed with Nano-conductive Particles", Composite Structures, 122, pp.23~30 (2015)
- Micheli, D., "Ballistic and Electromagnetic Shielding Behaviour of Multifunctional Kevlar Fiber Reinforced Epoxy Composites Modified by Carbon Nanotubes", Carbon, 104, pp.141~156 (2016)
- Nam, Y. W., "Thin Broadband Microwave Absorber with Conductive and Magnetic Materials Coated on a Glass Fabric", Journal of Composite Materials, 52(10), pp.1413~1420 (2018)
- Nam, Y. W., "Fabrication of a Thin and Lightweight Microwave Absorber Containing Nicoated Glass Fibers by Electroless Plating", Composites Science and Technology, 145, pp.165~172 (2017)
- Nam, Y. W., "Thin and Lightweight Radar-absorbing Structure Containing Glass Fabric Coated with Silver by Sputtering", Composite Structures, 160(15), pp.1171~1177 (2017)
- Nam, Y. W., "Multifunctional Aramid", epoxy Composite for Stealth Space Hypervelocity Impact Shielding System, 2018, pp.193, 113~120
- Choi, W. H., "Space Hypervelocity Impact-shielding and Microwave Absorbing Composite Composed of Cobalt-coated Aramid Fibers", Composite Structures, 266, pp.113875~ (2021)
- 최재훈, "반도체 섬유 강화 복합재료를 이용한 전자파 흡수 구조", Composites Research, 29(3), pp.98~103 (2016), 한국복합재료학회
- Schoeppner, G. A., "Delamination Threshold Loads for Low Velocity Impact on Composite Laminates", Composites Part A : Applied Science and Manufacturing, 31(9), pp.903~915 (2000)
- Kim, H., "Modeling Hail Ice Impacts and Predicting Impact Damage Initiation in Composite Structures", AIAA Journal, 38, pp.1278~1288 (2000)
- Kim, C. H., "Impact Characteristics of Composite Panel Stitched by I-fiber Process", Composites Part A : Applied Science and Manufacturing, 127, pp.105644~ (2019)
- 하승철, "저속충격을 받는 복합적층판의 충격거동에 대한 확률분포 특성", Composites Research, 22(6), pp.18~22 (2009), 한국복합재료학회
- Eun, S. W., "Effect of Delamination on the Electromagnetic Wave Absorbing Performance of Radar Absorbing Structures", Composites Science and Technology, 116, pp.18~25 (2015)
- Go, J. I., "Electromagnetic Damage Tolerance for Radar Absorbing Composite Structure with Impact Damage", Composites Science and Technology, 199, pp.108366~ (2020)
- Costa, F., "Electromagnetic Absorbers Based on Frequency Selective Surfaces", Forum for Electromagnetic Research Methods and Application Technologies (FERMAT), 37(1) (2016)
- 최광식, "X-Band 영역에서의 세라믹", 샌더스트-알루미노실리케이트 복합재의 초고온 전자파 흡수 거동, 2022, pp.35(3), 201~215[DOI]