물-결합재 비와 잔골재-결합재 비에 따른 알칼리 활성화 슬래그 모르타르의 기초특성
The Fundamental Properties of Alkali-Activated Slag Cement (AASC) Mortar with Different Water-Binder Ratios and Fine Aggregate-Binder Ratios
1
조회
0
다운로드
3
인용
0
참고문헌
키워드
초록
본 연구는 물-결합재 비 (W/B)와 잔골재-결합재 비 (F/B)에 따른 알칼리 활성화 슬래그 시멘트 (AASC)의 기초 특성에 관한 연구이다. W/B 비는 0.35, 0.40, 0.45, 그리고 0.50를 선정하였다. 그리고 F/B 비는 1.00에서 3.00까지 0.25 크기로 고려하였다. 알칼리 활성화제는 2M과 4M의 NaOH를 사용하였다. 실험은 플로우, 흡수율, 압축강도, 초음파 속도 그리고 건조수축을 측정하여 비교하였다. 플로우, 압축강도, 흡수율, 초음파 속도 그리고 건조수축 모두 W/B 비가 증가하면 감소하였다. 압축강도는 동일 W/B 비에서 F/B 비가 증가할수록 감소 하였다. 또한 특정 F/B 비에서 강도가 증가하는 것을 볼 수 있었다. 그리고 S2 (river sand 2)는 S1 (river sand 1)보다 낮은 물리적 특성을 나타냈는데, 이는 조립률 때문으로 판단된다. 본 실험의 결과 AASC의 공학적 특성은 W/B 비와 F/B 비가 영향을 주는 것으로 판단된다. 최적의 F/B 비는 각 W/B 비에 대해 1.75~2.50 인 것으로 생각된다. 또한 W/(B+F) 비가 0.13과 0.14 사이일 때 AASC 모르타르의 배합설계가 효과적일 것으로 판단된다.
Abstract
This study investigates the fundamental properties of the water-binder (W/B) ratio and fine aggregate-binder (F/B) ratio in the alkali-activated slag cement (AASC) mortar. The W/B ratios are 0.35, 0.40, 0.45, and 0.50, respectively. And then the F/B ratios varied between 1.00 and 3.00 at a constant increment of 0.25. The alkali activator was an 2M and 4M NaOH. The measured mechanical properties were compared, flow, compressive strength, absorption, ultra sonic velocity, and dry shrinkage. The flow, compressive strength, absorption, ultra sonic velocity and dry shrinkage decreased with increases W/B ratio. The compressive strength decreases with increase F/B ratio at same W/B ratio. Also, at certain value of F/B ratio significant increase in strength is observed. And S2 (river sand 2) had lower physical properties than S1 (river sand 1) due to the fineness modulus. The results of experiments indicated that the mechanical properties of AASC depended on the W/B ratio and F/B ratio. The optimum range for W/B ratios and F/B ratios of AASC is suggested that the F/B ratios by 1.75~2.50 at each W/B ratios. Moreover, the W/(B+F) ratios between 0.13 and 0.14 had a beneficial effect on the design of AASC mortar.
참고문헌 (19)
- Atis, C. D., "Influence of activator on the strength and drying shrinkage of alkaliactivated slag mortar", Construction and Building Materials, 23, pp.548~555 (2009)
- Bernal, S. A., "Effect of binder content on the performance of alkali-actiated slag concretes", Cement and Concrete Research, 41, pp.1~8 (2011)
- Bilim, C., "Influence of admixtures on the properties of alkali-activated slag mortars subjected to different curing conditions", Materials and Design, 44, pp.540~547 (2013)
- Burciaga-Diaz, O., "Mortars of alkali-activated blast furnace slag with high aggregate : binder ratios", Construction and Building Materials, 44, pp.607~614 (2013)
- Chi, M., "Binding mechanism and properties of alkali-activated fly ash", slag mortars, 2013, pp.40, 291~298
- Collins, F., "Effect of pore size distribution on drying shrinkage of alkali-activated slag concrete", Cement and Concrete Research, 30, pp.1401~1406 (2000)
- Han, C. G., "Influence of Grading and Grade Shape in Aggregate on the Strength and Absorption of Cement Mortar Products", Journal of the Korea Concrete Institute, 12(1), pp.45~51 (2000)
- Joseph, B., "Influence of aggregate content on the behavior of fly ash based geopolymer concrete", 19, pp.1188~1194 (2012), Sharif University of Technology
- 강수태, "바텀애쉬를 결합재로 사용한 알칼리 활성화 시멘트 모르타르의 최적배합에 관한 연구", 콘크리트학회 논문집, 23(4), pp.487~494 (2011), 한국콘크리트학회
- 김태완, "알칼리 활성화 슬래그 모르타르의 특성에 미치는 혼합 활성화제의 영향", 한국구조물진단유지관리공학회 논문집, 16(6), pp.26~33 (2012), 한국구조물진단유지관리공학회[DOI]
- Lee, W. K. W., "The interface between natural siliceous aggregates and geopolymers", Cement and Concrete Research, 34, pp.195~206 (2004)
- 이영재, "알칼리 활성화 슬래그 콘크리트의 적용에 관한 실험적 연구", 대한건축학회논문집 구조계, 23(2), pp.99~106 (2007), 대한건축학회
- Li, C., "A review: The comparison between alkali-activated slag (Si+Ca) and metakaolin (Si+Al) cements", Cement and Concrete Research, 40, pp.1341~1349 (2010)
- Neto, A. A. M, "Drying and autogenous shrinkage of pastes and mortars with activated slag cement", Cement and Concrete Research, 38, pp.565~574 (2008)
- Pacheco-Torgal, F., "Alkaliactivated binders: A review: Part 1. Historical background, terminology, reaction mechanism and hydration products", Construction and Building Materials, 22, pp.1305~1314 (2008)
- Pacheco-Torgal, F., "Investigations about the effect of aggregates on strength and microstructure of geopolymeric mine waste mud binders", Cement and Concrete Research, 37, pp.933~941 (2007)
- Ruiz-Santaquiteria, C., "Alkaline solution", binder ratio as a determining factor in the alkaline activation of aluminosilicates, 2012, pp.42, 1242~1251
- Yang, K. H., "Effect of waterbinder ratio on the mechanical properties of calcium hydroxidebased alkali-activated slag concrete", Construction and Building Materials, 29, pp.504~511 (2012)
- Yang, K. H., "Flow and Compressive Strength of Alkali-Activated Mortars", ACI Materials Journal, 106, pp.50~57 (2009)