제강 슬래그 잔골재가 혼입된 초속경 시멘트 기반 스마트 보수재료의 전기역학적 특성
Electromechanical Properties of Smart Repair Materials based on Rapid Setting Cement Including Fine Steel Slag Aggregates
0
조회
0
다운로드
0
인용
0
참고문헌
키워드
초록
본 연구에서는 제강 슬래그 (fine steel slag aggregates, FSSAs) 혼입량에 따른 스마트 보수재료 (smart repair materials, SRMs)의 전기역학적 거동을 조사하였다. SRMs는 보수 품질을 스스로 진단하고 보수 부위의 손상을 자체적으로 감지할 수 있다. FSSAs는 SRMs에 모래중량 대비 0% (FSSA00), 25% (FSSA25), 그리고 50% (FSSA50) 치환되어 혼입되었다. SRMs의 전기저항률은 일반적으로 압축 응력이 증가함에 따라 감소하였다: 재령 7시간 기준 FSSA25의 전기저항률은 압축 응력이 0에서 22.57 MPa로 증가함에 따라 78.16에서 63.68 kΩ-cm으로 감소하였다. FSSAs의 모래 중량 대비 치환율이 0%에서 25%로 증가함에 따라 재령 7시간 기준 응력 민감도 (stress sensitivity coefficient, SSC)는매트릭스 내 부분적인 전도성 경로 수의 증가로 인해 0.471에서 0.828 %/MPa로 증가하였다. 하지만, 치환율이 50%까지 증가함에 따라 부분적인 전도성 경로들의 일부가 연속적인 전도성 경로로 변화하여 SSC는 0.828에서 0.649 %/MPa로 감소하였다. SRMs는 보수 부위의 전기저항률만을 측정하는 것으로 보수 품질을 진단하고 보수 부위의 추가 손상을 스스로 감지할 수 있을 뿐만 아니라 구조물의 역학적 성능을 빠르게 회복시킬 수 있을 것으로 기대한다.
Abstract
This study investigated the electromechanical properties of cement based smart repair materials (SRMs) according to the different amounts of fine steel slag aggregates (FSSAs). SRMs can self-diagnose the quality of repairing and self-sense the damage of repaired zone. The replacement ratios of FSSAs to sand for SRMs were 0% (FSSA00), 25% (FSSA25), and 50% (FSSA50) by sand weight. The electrical resistivity of SRMs generally decreased as the compressive stress of SRMs increased: the electrical resistivity of FSSA25 at the age of 7 hours decreased from 78.16 to 63.68 kΩ-cm as the compressive stress increased from 0 to 22.37 MPa. As the replacement ratio of FSSAs by weight of sand increased from 0% to 25%, the stress sensitivity coefficient (SSC) of SRM at the age of 7 h increased from 0.471 to 0.828 %/MPa owing to the increased number of partially conductive paths in the SRMs. However, as the replacement ratio of FSSAs further increased up to 50%, the SSC decreased from 0.828 to 0.649 %/MPa because some of the partially conductive paths changed to continued conductive ones. SRMs are expected to self-sense the quality and future damage of repaired zone only by measuring the electrical resistivity of the repaired zone in addition to fast recovery in the mechanical resistance of structures.
참고문헌 (28)
- Al-Gburi, M., "Reducing thermal crack risks caused by restraint in young concrete – a case study on walls of water tanks", Nordic Concrete Research, 66(1), pp.41~54 (2022), Sciendo
- Ann, T. H., "Development of convenient repair materials for the surface treatment method of cracked concrete", Journal of the Korea Institute for Structural Maintenance and Inspection, 20(1), pp.44~50 (2016)
- Assaad, J. J., "Development and use of polymer-modified cement for adhesive and repair applications", Construction and Building Materials, 163, pp.139~148 (2018), Elsevier Ltd
- Garbacz, A., "On the evaluation of interface quality in concrete repair system by means of impact-echo signal analysis", Construction and Building Materials, 134, pp.311~323 (2017), Elsevier Ltd
- Han, B., "Self-sensing concrete in smart structures" (2014), Elsevier
- Hashimoto, K., "Repair inspection technique based on elastic-wave tomography applied for deteriorated concrete structures, Elasticity of Materials - Basic Principles and Design of Structures" (2019), IntechOpen
- Jumaat, Z., "A review of the repair of reinforced concrete beams", Journal of Applied Science Research, 2(6), pp.317~326 (2006), Academia
- Kan, Y. C., "Experimental investigation of mode-I fracture toughness of real-cracked concrete repaired by epoxy", Construction and Building Materials, 293, pp.123490~ (2021), Elsevier Ltd
- 기성훈, "표면파 측정을 통한 콘크리트 슬래브의 표면균열 깊이 측정", 한국구조물진단유지관리공학회 논문집, 19(3), pp.104~112 (2015), 한국구조물진단유지관리공학회
- Kim, H. J., "Performance assessment method for crack repair in concrete using PZT-based electromechanical impedance technique", NDT and EInternational, 104, pp.90~97 (2019), Elsevier Ltd
- Kim, M. K., "Electromechanical response of smart ultra-high performance concrete under external loads corresponding to different electrical measurements", Sensors, 21, pp.1281~ (2021), MDPI
- 김태욱, "휨하중을 받는 스마트 초고강도 섬유보강 콘크리트의 전기역학적 거동 조사", 한국구조물진단유지관리공학회 논문집, 26(5), pp.57~65 (2022), 한국구조물진단유지관리공학회
- Kim, T. U., "Effects of temperature and humidity on self-stress sensing capacity of smart concrete blocks", Journal of Building Engineering, 69, pp.106227~ (2023), Elsevier Ltd
- Kim, T. U., "Development of a smart concrete block with an eccentric load sensing capacity", Construction and Building Materials, 306, pp.124881~ (2021), Elsevier Ltd
- Kwon, C. W., "Cement mortar strength properties of using high early strength cement and blast furnace slag powder", Proceedings of the Korea Institute for Structural Maintenance and Inspection Conference, pp.487~488 (2013)
- Le, H. V., "Enhancing self-stress sensing ability of smart ultra-high performance concretes under compression by using nano functional fillers", Journal of Building Engineering, 44, pp.102717~ (2021), Elsevier Ltd
- Le, H. V., "Effects of steel slag aggregate size and content on piezoresistive responses of smart ultra-high-performance fiber-reinforced concretes", Sensors and Actuators A : Physical, 305, pp.111925~ (2020), Elsevier Ltd
- Lee, S. Y., "Self-stress sensing smart concrete containing fine steel slag aggregates and steel fibers under high compressive stress", Construction and Building Materials, 220, pp.149~160 (2019), Elsevier Ltd
- Nalon, H. G., "Effects of different kinds of carbon black nanoparticles on the piezoresistive and mechanical properties of cement-based composites", Journal of Building Engineering, 32, pp.101724~ (2020), Elsevier Ltd
- Pang, B., "Study on the effect of waterborne epoxy resins on the performance and microstructure of cement paste", Construction and Building Materials, 167, pp.831~845 (2018), Elsevier Ltd
- Sevim, O., "Effects of graphene nanoplatelets type on self-sensing properties of cement mortar composites", Construction and Building Materials, 359, pp.129488~ (2022), Elsevier Ltd
- Suo, Y., "Study on self-sensing capabilities of smart cements filled with graphene oxide under dynamic cyclic loading", Journal of Building Engineering, 58, pp.104775~ (2022), Elsevier Ltd
- Wang, C., "Research on the mechanical behavior of a steel–concrete composite link slab on a simply supported girder bridge", Metals, 12, pp.1410~ (2022), MDPI
- Wang, H., "Influence of carbon nanofiber content and sodium chloride solution on the stability of resistance and the following self-sensing performance of carbon nanofiber cement paste", Case Studies in Construction Materials, 11, pp.e00247~ (2019), Elsevier Ltd
- Wang, L., "Health monitoring of C60 smart concrete based on self-sensing", Materials Today Communications, 35, pp.105834~ (2023), Elsevier Ltd
- Wang, X., "Mechanical properties improvement mechanism of silica fume-modified ultrafine cement used to repair pavement microcracks", Advances in Materials Science and Engineering, 2018, pp.4898230~ (2018), Hindawi
- Zhang, H., "Monitoring and evaluation of the repair quality of concrete cracks using piezoelectric smart aggregates", Construction and Building Materials, 317, pp.125775~ (2022), Elsevier Ltd
- Zhuang, S., "Inhibition mechanisms of steel slag on the early-age hydration of cement", Cement and Concrete Research, 140, pp.106283~ (2021), Elsevier Ltd