Fire Resistance Characteristics of Firewall Structure Associated with Impact Damage Induced by Explosion
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
When a fire accident accompanied by an explosion occurs, the surrounding firewalls are affected by impact and thermal loads. Damaged firewalls due to accidental loads may not fully perform their essential function. Therefore, this paper proposes an advanced methodology for evaluating the fire resistance performance of firewalls damaged by explosions. The fragments were assumed to be scattered, and fire occurred as a vehicle exploded in a large compartment of a roll-on/roll-off (RO-RO) vessel. The impact velocity of the fragments was calculated based on the TNT equivalent mass corresponding to the explosion pressure. Damage and thermal-structural response analyses of the firewall were performed using Ansys LS-DYNA code. The fire resistance reduction was analyzed in terms of the temperature difference between fire-exposed and unexposed surfaces, temperature increase rate, and reference temperature arrival time. The degree of damage and the fire resistance performance of the firewalls varied significantly depending on impact loads. When naval ships and RO-RO vessels that carry various explosive substances are designed, it is reasonable to predict that the fire resistance performance will be degraded according to the explosion characteristics of the cargo.
Abstract
When a fire accident accompanied by an explosion occurs, the surrounding firewalls are affected by impact and thermal loads. Damaged firewalls due to accidental loads may not fully perform their essential function. Therefore, this paper proposes an advanced methodology for evaluating the fire resistance performance of firewalls damaged by explosions. The fragments were assumed to be scattered, and fire occurred as a vehicle exploded in a large compartment of a roll-on/roll-off (RO-RO) vessel. The impact velocity of the fragments was calculated based on the TNT equivalent mass corresponding to the explosion pressure. Damage and thermal-structural response analyses of the firewall were performed using Ansys LS-DYNA code. The fire resistance reduction was analyzed in terms of the temperature difference between fire-exposed and unexposed surfaces, temperature increase rate, and reference temperature arrival time. The degree of damage and the fire resistance performance of the firewalls varied significantly depending on impact loads. When naval ships and RO-RO vessels that carry various explosive substances are designed, it is reasonable to predict that the fire resistance performance will be degraded according to the explosion characteristics of the cargo.
참고문헌 (18)
- European Committee Standardization, "Eurocode 1: Actions on structures – Part 1-2: General actions – Actions on structures exposed to fire (BS EN 1991-1-2)", ~ (1991)
- European Committee Standardization, "Eurocode 3: Design of steel structures – Part 1-2: General rules – Structural fire design (BS EN 1993-1-2)", ~ (2005)
- Center for Chemical Process Safety(CCPS)., "Guidelines for chemical process quantitative risk analysis" (1999), Wiely
- 정준모, "조선 해양 구조물용 강재의 소성 및 파단 특성 IV: 고온 기계적 물성치에 관한 실험적 연구", 한국해양공학회지, 25(3), pp.66~72 (2011), 한국해양공학회
- Strain-hardening and strain-rate effects in the impact loading of cantilever beams, "Cowper, G. R.", Division of Applied Mathematics, Brown University, ~, pp.Technical Report No. 28 (1957)
- D’Amore, G. K. O., "Numerical modeling of fire resistance test as a tool to design lightweight marine fire doors : A preliminary study", Journal of Marine Science and Engineering, 8(7), pp.520~ (2020)[DOI]
- Federal Emergency Management Agency(FEMA)., "Risk management series: design guidance for shelters and safe rooms (FEMA 453)", FEMA, ~ (2006)
- International Maritime Organization(IMO)., "Chapter II-2 of SOLAS: construction – fire protection, fire detection and fire extinction", ~ (2002)
- 김정환, "해양플랜트 구조물의 화재 사고 시 PFP 효과를 고려한 비선형 구조응답 해석 기법에 대한 연구", 한국해양공학회지, 28(4), pp.294~305 (2014), 한국해양공학회
- Livermore Software Technology Corporation(LSTC)., "User’s manual for LS-DYNA", LSTC, ~ (2018)
- Newmark N. M., "Shock and vibration handbook, Vol. 3: design of blast resistant structures" (1961), McGraw-Hill
- Paik, J. K., "Test database of the mechanical properties of mild, high-tensile and stainless steel and aluminium alloy associated with cold temperatures and strain rates", Ships and Offshore Structures, 12(sub1), pp.s230~s256 (2017)
- 박대겸, "Effects of the structural strength of fire protection insulation systems in offshore installations", International Journal of Naval Architecture and Ocean Engineering, 13, pp.493~510 (2021), 대한조선학회[DOI]
- 박우창, "A60급 구획 적용 격벽 관통용 관의 열전달 특성 II: 관 재질 및 단열재 종류에 따른 방화시험", 한국해양공학회지, 33(4), pp.340~349 (2019), 한국해양공학회[DOI]
- 박우창, "Evaluation on Sensitivity and Approximate Modeling of Fire-Resistance Performance for A60 Class Deck Penetration Piece Using Heat-Transfer Analysis and Fire Test", 한국해양공학회지, 35(2), pp.141~149 (2021), 한국해양공학회[DOI]
- Seo, J. K., "A method for determining fire accidental loads and its application to thermal response analysis for optimal design of offshore thin-walled structures", Fire Safety Journal, 92, pp.107~121 (2017)[DOI]
- Transportation Safety Board of Canada, "Statistical summary: marine transportation occurrences in 2020" (2020), TSB
- U. S. Department of defense., "Department of defense standard practice: fire resistance of U.S. naval surface ships (MIL-STD-3020)", ~ (2007)