Upper housing 제품의 드로잉공정에 의한 두께 변형 고찰
A study on the deformation of thickness by drawing process ofupper housing products
2
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
For manufacturing upper housing product of mechanical control valve, the progressive drawing process was conducted experimental. Then, the center of the product was cut to measure the thickness of the product. As a result, the following conclusions were obtained. By means of a stand-alone pad provided with sufficient pressure, it is possible to prevent the occurrence of wrinkles in the die pad product of the drawing process. As a result of the experiment, it was considered that the flange bottom of the product and the lower edge of the product are made thick in thickness, the top edge and the top surface are thin. It is considered that this is due to the size and roughness of the entrance edge radius of the die in the drawing process, and the inflow of the material by the die pad.
Abstract
For manufacturing upper housing product of mechanical control valve, the progressive drawing process was conducted experimental. Then, the center of the product was cut to measure the thickness of the product. As a result, the following conclusions were obtained. By means of a stand-alone pad provided with sufficient pressure, it is possible to prevent the occurrence of wrinkles in the die pad product of the drawing process. As a result of the experiment, it was considered that the flange bottom of the product and the lower edge of the product are made thick in thickness, the top edge and the top surface are thin. It is considered that this is due to the size and roughness of the entrance edge radius of the die in the drawing process, and the inflow of the material by the die pad.
참고문헌 (6)
- Investigation of Deep Drawability and Product Qualities of Ultra Thin Sheet Metal, "Lee, Ki-Sung", ~
- 이사랑, "타원형 다단 딥 드로잉 제품의 성형성 향상을 위한초기 소재 형상 최적 설계", 한국산학기술학회논문지, 17(10), pp.696~701 (2016), 한국산학기술학회[DOI]
- 이춘규, "프레스 끼임 재해 사례분석을 통한 안전금형 모델 연구", 대한안전경영과학회지, 15(2), pp.71~77 (2013), 대한안전경영과학회[DOI]
- 이춘규, "Test Work 드로잉 금형의 설계 및 제작에 관한 연구", Design & Manufacturing, 12(1), pp.13~17 (2018), 한국금형공학회[DOI]
- Chun-Kyu Lee, "A study on Changes in Thickness of STS304 Material in the Progressive Drawing process", Arch. Metall. Mater, 62(2B), pp.1319~1323 (2017)
- 이춘규, "PCB 장착을 위한 원형 포밍형상의 재료 두께 변형에 관한 연구", 한국산학기술학회논문지, 16(6), pp.3667~3671 (2015), 한국산학기술학회[DOI]