MLCC를 이용한 SMPS의 EMI 저감 설계
Design of EMI Reduction of SMPS Using MLCC Filters
0
조회
0
다운로드
1
인용
0
참고문헌
키워드
초록
최근 초고속 이더넷(ethernet)의 데이터 및 동작주파수 속도가 증가하고 있으며, 이에 따라 EMI (electromagnetic interference)가 증가하고 있다. 이러한 EMI의 발생은 주변 전자기기들에 영향을 미쳐 오동작 원인이 될가능성이 높다. 본 연구에서는 고속 이더넷 스위치 EMI 발생의 주요 원인인 DC-DC SMPS (switching mode power supply)에서 발생하는 EMI 저감을 위해 EMI 필터를 적용하였다. EMI 필터소자는 소형화, 양산화에 장점을 가지며, 내전압(dielectric voltage) 특성이 우수한 MLCC (multi-layer ceramic capacitor)를 사용하였다. MLCC 필터는 X-커패시터및 X, Y-커패시터로 구성되어 있다. X-커패시터는 10 nF 및 100 nF 용량의 2개의 MLCC와 1개의 마일러 콘덴서(mylar capacitor)로 구성하였다. Y-커패시터는 용량 27 nF의 6개의 MLCC를 사용하여 구성하였다. X-커패시터만을 EMI 필터로 적용한 경우, 전도성(conductive) EMI는 150 kHz ~ 30 MHz의 주파수 대역에서 EMI 전계강도가 허용 한계치를 초과함을 알 수 있었다. 또한 방사성(radiative) EMI도 특정 주파수에서 EMI 전계 강도가 높고, 허용 마진폭도 매우 적음을알 수 있었다. 반면 X, Y-커패시터를 적용하였을 경우, 전 주파수 대역에서 전도성 EMI가 크게 감소하였으며, 방사선EMI도 충분한 마진이 확보됨을 알 수 있었다. 또한 X, Y-커패시터의 전기적인 신뢰성을 평가하기 위하여 절연 저항(insulation resistance) 및 내전압 성능을 측정하였으며, 절연 저항 및 내저항 성능이 모두 전기적 신뢰성 기준을 만족함을알 수 있었다. 결론적으로 MLCC 필터를 X, Y-커패시터로 사용하여 전도성 및 방사성 EMI 노이즈가 효과적으로 감소되었고, 우수한 전기적인 신뢰성도 확보됨을 알 수 있었다.
Abstract
Recently, as the data speed and operating frequencies of Ethernet keeps increasing, electro magnetic interference (EMI) also becomes increasing. The generation of such EMI will cause malfunction of near electronic devices. In this study, EMI filters were applied to reduce the EMI generated by DC-DC SMPS (switching mode power supply), which is the main cause of EMI generation of Ethernet switch. As the EMI filter, MLCCs with excellent withstanding voltage characteristics were used, which had advantages in miniaturization and mass production. Two types of EMI MLCC filters were used, which are X-capacitor and X, Y-capacitor. X-capacitor was composed of 2 MLCCs with 10 nF and 100 nF capacity and 1 Mylar capacitor. Y-capacitor was consisted of 6 MLCCs with a capacity of 27 nF. When only Xcapacitor was applied as EMI filter, the conductive EMI field strength exceeded the allowable limit in frequency range of 150 kHz ~ 30 MHz. The radiative EMI also showed high EMI strength and very small allowable margin at the specific frequencies. When the X and Y-capacitors were applied, the conductive EMI was greatly reduced, and the radiation EMI was also found to have sufficient margin. In addition, X, Y-capacitors showed very high insulation resistance and withstanding resistance performances. In conclusion, EMI X, Y-capacitors using MLCCs reduced the EMI noise effectively and showed excellent electrical reliability.
참고문헌 (18)
- S. -D. Kim, "Electronic interference (EMI)countermeasure technology for computers and information communication devices", The Korean Institute of Illumination and Electrical Installation Engineers, 13(4), pp.15~ (1999)
- M. Podbersic, "An EMI Filter Selection Method Based on Spectrum of Digital Periodic Signal", MDPI sensor, 6(3), pp.90~ (2006)
- S.-H. Ryu, "PCB Layout Optimization Using External LDO for Low EMI", Proc. International Conference on Consumer Electronics (ICCE), pp.610~ (2015), IEEE
- Y. S. Cao, "PCB Edge Shielding Effectiveness Evaluation and Design Guidelines", Proc. Symposium on Electromagnetic Compatibility. Signal Integrity and Power Integrity (EMC. SI & PI), pp.269~ (2018), IEEE
- A. Keenan, "Board Level EMI Suppression using Ferrite Components", Proc. International Symposium on Electromagnetic Compatibility (EMC), pp.1252~ (2003), IEEE
- D. Tarasov, "On Increase of Immunity to EMI in High Performance Analog System with Differential Signal Line", Proc. 6th Mediterranean Conference on Embedded Computing (MECO), pp.1~ (2017), IEEE
- K. Joo, "Package-Level EMI Shielding Technology with Silver Paste for Various Applications", Proc. 67th Electronic Components and Technology Conference (ECTC), pp.1736~ (2017), IEEE
- 김상우, "RF대역 노이즈 저감용 연자성 필름의 전자기파 차폐효과", 마이크로전자 및 패키징학회지, 11(3), pp.31~36 (2004), 한국마이크로전자및패키징학회
- 유지우, "Electrospun Magnetic Nanofiber as Multifunctional Flexible EMI-Shielding Layer and its Optimization on the Effectiveness", 마이크로전자 및 패키징학회지, 23(2), pp.57~63 (2016), 한국마이크로전자및패키징학회
- 장진수, "전위계차센서 기반 스마트TV 제어를 위한 극저주파 전자기간섭 제거 연구", 멀티미디어학회논문지, 18(3), pp.401~407 (2015), 한국멀티미디어학회[DOI]
- J. -S. Kim, "SMPS EMC", EMS Technology trend and countermeasure technology, 2019, pp.30(1), 29~
- J. Kulanayagam, "New Efficient Filter Design for a Heat sink", RE&PQJ, 1(9), pp.581~ (2011)
- G. Felic, "Study of Heat sink EMI Effects in SMPS Circuits", Proc. IEEE EMC International Symposium. Symposium Record. International Symposium on Electromagnetic Compatibility, pp.254~ (2001), IEEE
- J. -W. Lee, "A Study on the Low Noise Medical SMPS", Korea Academy Industrial Cooperation Society, 53 (2001)
- C.-H. Jun, "The Design Method of Y-Capacitor Reducing CMNoise in HV Inverter Motor System", Proc. The Korean Society of Automotive Engineers Autumn Conference and Exhibition, pp.629~ (2016)
- H.-P. Park, "Parallel-Series LLC Resonant Converter using Spread Spectrum Technique of Switching Frequency for Suppressing EM Noise", Proc. Korean Institute of Electrical Engineers Conference, pp.811~ (2018)
- Y.-C. Son, "A Novel Active Common-mode EMI Filter for Mitigating Conducted EMI", Proc. Power Electronics Conference, The Korea Institute of Power Electronics, pp.91~ (2002)
- N.-H. Byeon, "A Study of EMI Noise Reduction for Boost Converter Considering Circuit Design Shape", Proc. The Korean Institute of Electrical Engineers Conference, pp.1017~ (2014)