MD 시뮬레이션을 이용한 실린더 형태 나노와이어의 접촉면적에 관한 연구
Determination of Contact Area of Cylindrical Nanowire using MD Simulation
0
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
Contact between solid surfaces is one of the most important factors that influence dynamic behavior in micro/nanoscale. Although numerous theories and experimental results on contact behavior have been proposed, a thorough investigation for nanomaterials is still not available owing to technical difficulties. Therefore, molecular dynamics simulation was performed to investigate the contact behavior of nanomaterials, and the application of conventional contact theories to nanoscale was assessed in this work. Particularly, the contact characteristics of cylindrical nanowires were examined via simulation and contact theories. For theoretical analysis, various contact models were utilized and work of adhesion, Hamaker constant and elastic modulus those are required for calculation of the models were obtained from both indentation simulation and tensile simulation. The contact area of the cylindrical nanowire was assessed directly through molecular dynamics simulation and compared with the results obtained from the theories. Determination of the contact area of the nanowires was carried out via simulation by counting each atom, which is within the equilibrium length. The results of the simulation and theoretical calculations were compared, and it was estimated that the discrepancy in the results calculated between the simulation and the theories was less than 10 except in the case of the smallest nanowires. As the result, it was revealed that contact models can be effectively utilized to assess the contact area of nanomaterials.
Abstract
Contact between solid surfaces is one of the most important factors that influence dynamic behavior in micro/nanoscale. Although numerous theories and experimental results on contact behavior have been proposed, a thorough investigation for nanomaterials is still not available owing to technical difficulties. Therefore, molecular dynamics simulation was performed to investigate the contact behavior of nanomaterials, and the application of conventional contact theories to nanoscale was assessed in this work. Particularly, the contact characteristics of cylindrical nanowires were examined via simulation and contact theories. For theoretical analysis, various contact models were utilized and work of adhesion, Hamaker constant and elastic modulus those are required for calculation of the models were obtained from both indentation simulation and tensile simulation. The contact area of the cylindrical nanowire was assessed directly through molecular dynamics simulation and compared with the results obtained from the theories. Determination of the contact area of the nanowires was carried out via simulation by counting each atom, which is within the equilibrium length. The results of the simulation and theoretical calculations were compared, and it was estimated that the discrepancy in the results calculated between the simulation and the theories was less than 10 except in the case of the smallest nanowires. As the result, it was revealed that contact models can be effectively utilized to assess the contact area of nanomaterials.
참고문헌 (25)
- 김현준, "Nano-scale Friction : A Review", International Journal of Precision Engineering and Manufacturing, 10(2), pp.141~151 (2009), 한국정밀공학회
- 김형규, "트라이볼로지 손상을 억제하기 위한 구조물 모서리부 설계: 제1부 - 설계공식 개발", 한국윤활학회지, 31(4), pp.163~169 (2015), 한국윤활학회[DOI]
- 남승국, "멀티스케일 해석을 통한 히스테리시스 고무 마찰 예측 연구", 한국윤활학회지, 30(6), pp.378~383 (2014), 한국윤활학회[DOI]
- Moyar, G. J., "An analysis of the thermal contributions to railway wheel shelling", Wear, 144, pp.117~138 (1991)
- Persson, B. N. J., "Theory of rubber friction and contact mechanics", J. Chem. Phys, 115(8), pp.3840~3861 (2001)
- Eriksson, M., "Tribological surfaces of organic brake pads", Tribol. Int, 33, pp.817~827 (2000)
- Chen, S., "Generalized Maugis–Dugdale model of an elastic cylinder in non-slipping adhesive contact with a stretched substrate", Int. J. Mat. Res, 97, pp.584~593 (2006)
- Shi, X., "Comparison of various adhesion contact theories and the influence of dimensionless load parameter", J. Adhesion Sci. Technol, 18(1), pp.55~68 (2004)
- Persson, B. N. J., "Contact mechanics for randomly rough surfaces", Surf. Sci. Rep, 61, pp.201~227 (2006)
- Horstemeyer, M. F., "Atomistic finite deformation simulation : a discussion on length scale effects in relation to mechanical stresses", J. Eng. Mater. Technol, 121, pp.114~119 (1999)
- Tymiak, N. I., "Plastic strain and strain gradients at very small indentation depths", Acta Mater, 49, pp.1021~1034 (2001)
- Ou, Z. Y., "Fundamental solutions to Hertzian contact problems at nanoscale", Acta Mech, 224, pp.109~121 (2013)
- Kim, H. -J., "Sliding and rolling frictional behavior of a single ZnO nanowire during manipulation with an AFM", Nanoscale, 5, pp.6081~6087 (2013)
- Bordag, M., "Shear Stress Measurements on InAs Nanowires by AFM Manipulation", Small, 3, pp.1398~1401 (2007)
- Wang, Z. L., "Piezoelectric Nanogenerators Based on Zinc Oxide Nanowire Arrays", Science, 312, pp.242~246 (2006)
- 김현준, "실린더 형태의 나노와이어와 표면 사이의 응착력 평가를 위한 분자동역학 시뮬레이션 연구", 한국윤활학회지, 31(6), pp.264~271 (2015), 한국윤활학회[DOI]
- Oommen, B., "Effects of nanoscale thickness and elastic nonlinearity on measured mechanical properties of polymeric films", Thin Solid Films, 513, pp.235~242 (2006)
- Zhao, J., "Size-dependent mechanical behavior of nanoscale polymer particles through coarse-grained molecular dynamics simulation", Nanoscale Res. Lett, 8, pp.541~ (2013)
- Sung, I. -H., "Molecular dynamics simulation study of the nano-wear characteristics of alkanethiol self-assembled monolayers", Appl. Phys. A, 81, pp.109~114 (2005)
- Kim, H. -J., "Molecular dynamics simulation of atomic-scale frictional behavior of corrugated nano-structured surfaces", Nanoscale, 4, pp.3937~3944 (2012)
- Peng, Y. F., "An elastic adhesion model for contacting cylinder and perfectly wetted plane in the presence of meniscus", Trans. ASME J. Tribology, 129, pp.231~234 (2007)
- Muller, V. M., "On two methods of calculation of the force of sticking of an elastic sphere to a rigid plane", Colloid. Surface, 7, pp.251~259 (1983)
- Jin, F., "Adhesion between elastic cylinders based on the double-Hertz model", Int. J. Solids Struct, 51, pp.2706~2712 (2014)
- Maugis, D., "Adhesion of spheres : The JKR-DMT transition using a dugdale model", J. Colloid Interface Sci, 150, pp.243~269 (1992)
- Baney, J. M., "A cohesive zone model for the adhesion of cylinders", J. Adhes. Sci. Technol, 11, pp.393~406 (1997)