거친 표면의 돌기 방향성에 따른 EHL 해석
EHL Analysis for Rough Surface with Directional Roughness
0
조회
0
다운로드
2
인용
0
참고문헌
키워드
초록
This paper presents EHL analysis for rough surfaces with directional roughness. Three different types of surfaces with pure longitudinal roughness, pure transversal roughness and isotropic roughness are generated. For the surfaces with longitudinal and transversal roughness, two cases are analyzed; one is a case of asperity peak on a spherical contact center, the other one is of valley on a spherical contact center. As a results, the surface with pure transversal roughness gives higher pressure and smaller minimum film thickness than the surface with pure longitudinal roughness, and the surface with isotropic roughness has similar EHL behavior with the surface with pure transversal roughness.
Abstract
This paper presents EHL analysis for rough surfaces with directional roughness. Three different types of surfaces with pure longitudinal roughness, pure transversal roughness and isotropic roughness are generated. For the surfaces with longitudinal and transversal roughness, two cases are analyzed; one is a case of asperity peak on a spherical contact center, the other one is of valley on a spherical contact center. As a results, the surface with pure transversal roughness gives higher pressure and smaller minimum film thickness than the surface with pure longitudinal roughness, and the surface with isotropic roughness has similar EHL behavior with the surface with pure transversal roughness.
참고문헌 (10)
- Chang, L, "A Deterministic Model for Line Contact Partial Elasto-hydrodynamic Lubrication", Triblo. Int., 28(2), pp.75~84 (1995)
- Lubrecht, A.A, "The Influence of Longitudinal and Transverse Roughness on the Elastohydrodynamic Lubrication of Circular Contacts", Journal of Tribology ASME, 110, pp.421~426 (1988)
- Patir, N, "An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial hydrodynamic Lubrication", ASME, J. Lubri. Tech., 100, pp.12~17 (1978)
- T. W. Kim, "The Flow Factors Considering the Elastic Deformation for the Rough Surface with a Non-Gaussian Height Distribution", Tribology Transactions, 51(2), pp.213~220 (2008)
- C. H. Venner, "Surface Roughnesseffects in an EHL Line Contact", ASME, J. Tribol, 114(4), pp.616~622 (1992)
- Venner, C.H, "Transient Analysis of Surface Features in an EHL Line Contact in the Case of Sliding", ASME Journal of Tribology, 116, pp.186~193 (1994)
- Zhu, D, "Point Contact EHL Based on Optically Measured Three-Dimensional Rough Surfaces", ASME Journal of Triblolgy, 119(3), pp.375~384 (1997)
- Love A. E. H, "Stress Produced in a Semi-Infinite Solid by Pressure on Part of the Boundary", Phil. Trans. Royal Society, A228, pp.377~420 (1929)
- Roelands, C. J. A, "Correlational Aspects of the Viscosity- temperature-pressure Relationship of Lubricating Oils" (1966), Druk, V.R.B
- Dowson, D, "Elastohydrodynamic Lubrication" (1966), Perga-mon