Synthetic Hydrotalcite가 클로로프렌 고무 발포체의 내염수성에 미치는 영향 연구
Effect of Synthetic Hydrotalcite on Salt Water Resistance of Chloroprene rubber Foam
0
조회
0
다운로드
3
인용
0
참고문헌
키워드
초록
In this study, we investigated for synthetic hydrotalcite in chloroprene rubber foam. Experiments were carried out to find the optimum content ratio by controlling the contents of MgO and Hydrotalcite. Swelling test in toluene immersion was made to measure the crosslinking density of CR foams, and the cure properties were investigated with flat die rheometer and Mooney viscosity. The difference of hardness, tensile strength and elongation at break were observed after immersing in 7% NaCl or 21% NaCl solutions for a day and four days. In addition, the volume change and water content remaining in CR foam were measured after immersing NaCl solution. As content of MgO increased, the value of the cure torque tended to increase, but it was almost constant above 2phr of MgO. However, the Mooney viscosity decreased with increasing MgO content. The crosslinking density, determined by the swelling ratio, showed that the CR compound without MgO showed a higher degree of swelling. When the content of hydrotalcite/MgO was 3:2, it was the lowest volume change of CR form. Also, As the content of hydrotalcite decreased, the difference of mechanical properties before and after immersion NaCl solution increased.
Abstract
In this study, we investigated for synthetic hydrotalcite in chloroprene rubber foam. Experiments were carried out to find the optimum content ratio by controlling the contents of MgO and Hydrotalcite. Swelling test in toluene immersion was made to measure the crosslinking density of CR foams, and the cure properties were investigated with flat die rheometer and Mooney viscosity. The difference of hardness, tensile strength and elongation at break were observed after immersing in 7% NaCl or 21% NaCl solutions for a day and four days. In addition, the volume change and water content remaining in CR foam were measured after immersing NaCl solution. As content of MgO increased, the value of the cure torque tended to increase, but it was almost constant above 2phr of MgO. However, the Mooney viscosity decreased with increasing MgO content. The crosslinking density, determined by the swelling ratio, showed that the CR compound without MgO showed a higher degree of swelling. When the content of hydrotalcite/MgO was 3:2, it was the lowest volume change of CR form. Also, As the content of hydrotalcite decreased, the difference of mechanical properties before and after immersion NaCl solution increased.
참고문헌 (14)
- R. F. Ohm, "The Vanderbilt Rubber Handbook", pp.387~389 (1990), Vanderbilt Company Inc
- B. Adhikari, "Reclamation andRecycling of Waste Rubber", Progress in Polymer Science, 25(7), pp.909~ (2000)
- S. R. Scagliusi, "Study of Properties of Chloroprene Rubber Devulcanizate by Radiaion in Microwave", 2009 Internationa lNuclear Atlantic Conference-INAC, 41, pp.8~ (2009)
- A. N. Gent, "Engineering with Rubber : How to Design Rubber Components", pp.53~87 (2001), Hanser Gardner Publications
- R. B. Bagwell, "Effect of Seeding and Water Vapor on theNucleation and Growth of α-Al2O3from γ-Al2O3", Journal of the American Ceramic Society, 82(4), pp.824~ (1999)
- H. W. Starkweather, "Water Resistance of Neoprene", Industrial and Engineering Chemistry, 29(12), pp.1380~ (1937)
- C. Misra, "Composition and Properties of Synthetic Hydrotalcites", Clays and Clay Minerals, 40(2), pp.145~ (1992)
- K. Chibwe and W. Jones, "Intercalation of Organic and Inorganic Anions into Layered Double Hydroxides", J. Chem. Soc. Chem. Commun, 5(3), pp.926~ (1989)
- D. Lopez, "Preparation and Characterization of Poly(vinyl alcohol)-based Magnetic Nanocomposites. 1. Thermal andMechanical Properties", Journal of Applied Polymer Science, 82(13), pp.3215~ (2001)
- X. Jiang, "Modification of Poly(vinyl alcohol) Films by theAddition ofMagnesiumChlorideHexahydrate", Polymer Engineering and Science, 52(7), pp.1565~ (2012)
- I. Franta, "Elastomers and Rubber CompoundingMaterials : Manufacture, Properties and Applications", pp.375~407 (1989), Elsevier Science Publishers
- M. Meyn, "Anion-exchange Reactions of LayeredDoubleHydroxides", Materials Sci-ences and Application, 2(6), pp.5201~ (1990)
- K. A. Carrado, "Layered Double Hydroxides", Solid State Ionics, 26, pp.77~ (1988)
- W. T. Reichle, "Synthesis of Anionic Clay Minerals (Mixed Metal Hydroxides", Hydrotalcite), Solid State Ionics, 22, pp.135~ (1986)